TONGER® Pink Mushroom Projection Lamp

  • $16.99

  • Material:ABS+AS+PET
  • Size:12.3*12.3*10.8cm(4.84*4.84*4.25inch)
  • Power:recharge by USB cable( inclued)
  • Input Voltage / Current:5V 1000mA
  • Battery Capacity:1200mAh


Display and operation introduction
Instructions for projection function:
1. Align the hole position, open or close the light cover according to the instructions of the cover opening switch, and press the M key to project.
2. Description of projection lamp button M
Press firstly:Cold white light
Press secondly:Blue light
Press thirdly:Warm yellow light
Press fourthly:Three color flash light
Press fifth:Three mix light
Press sixth:3 second gradient light
Press seventh:Turn off light
3. In any light condition except for 3-second gradient, long press the key, the light will change from 100% to 5% and then stop, and then long press the “sun”sign again, the light will change from 5% to 100%, so on.

4. The projection light has memory function. It's brightness will be the same as the last time when you turn it off.(except for 3 second gradient)
5.This product takes about 3 hours to fully charge,and it can be used for about 5 hours when fully charged.The light is red when charging and green when fully charged.

1.Kids under the age of six should use this product under supervision of adults.
2. Do not disassemble the internal device by yourself to avoid damaging the parts.
3. When not use it for a long time, please place the product in a dry environment.
4. The light source of this lamp is irreplaceable; when the light source reaches its end of life, the whole lamp shall be replaced.
5. When assembling the upper and lower lamp covers, the lamp covers are not screwed in place and cannot be fastened.
6. Please use it on the platform with an inclination of no more than 6 degrees to prevent dumping.